http://www.sportident.com/en/en-support ... 5&siteid=0
Perso, sur mon PC j'en étais resté à la v.2.0.9, j'ai pas l'impression que les autres versions aient été rendue publiques.
Michel, ça serait sympa que la FFCO fasse un mailling à chaque mise à jour du matos SPORTident (soft ou firmware)
release notes
2.3.1 12.06.2012
Close COM port, if card read dialog is close
2.3.0 04.06.2012
removed unnecessary SI-Point settings
a warning is shown when computer time should be set and the difference is larger than 2 hours
SIAC bock 3: another identification
Help-File: new links for sportident
2.2.8 18.04.2012
header file for SIAC configuration added
2.2.7 31.03.2012
implemented modified D3 command
Config Card11, SIAC
New Battery SIAC
2.2.6 12.01.2012
SI-Point no write
2.2.5 05.01.2012
ProductID = CFG0 all bits (SI-Point=49)
2.2.4 04.10.2011
country code as a CLI parameter possible
Modes - BC D-Control und Instuction removed
Mode - D-Posten becomes SIAC ReadOutRadio
SIAC ReadOutRadio always with CN 127
bc Broadcast und bc Selective removed
BattCons/Cap label bei BS10_11 still undecided
2.2.0 03.03.2011
SIAC: Read backup
Switch to ClipBoard automatically
Show D3 'Timing mode' from SIAC
ScrollBar in main form for small screens
2.1.9 16.02.2011
SIAC direct control: show and select
release notes
2.1.8 14.02.2011
implemented SIAC configuration
BS11 settings (Beep, Led, Timing mode, Send by radio)
SIAC additional values: clear, start, finish, Batt.-Date und -Volt, Hard- und Software
2.1.7 12.01.2011
SIMSRR Dongle settings
Protocol new columns, new order
Instruction 'Password' removed
Batteries voltage registered in log file
2.1.3 07.09.2010
software no longer relevant for BS10_11, but for BS7, BS8
2.1.2 14.07.2010
software no longer relevant for BS10_11
operating time now equal to BS6
end address now equal to BS6
no message on capacity check
2.1.1 23.03.2010
CFG2 only USB or RS232
Dialog COM settings, if COM unavailably
No restriction "Operating mode" and CN
SIAC (SPORTidentActivCard) read backup (block 1, 4-7)
"Extended protocol" only set with Standard view
2.0.9 02.12.2009
Read cards with new board and not "Extended protocol"
.gif)
